Linndrum replacement powersupply
|Availability:||In stock (10)|
Linndrum power supply board
The Dtronics LinnPSU for linndrum gives you more stability, reliability and less heat.
The high-end onboard voltage regulator produces a clean and stable output.
There are 2 potmeters on board to adjust the main voltage and the memory voltage.
The board has a over current protection like the original.
The Linnpsu is easy to install. Replace that worn out powerboard that has been eaten by battery acid.
This new board has a battery holder so you can easy and fast replace any faulty battery.
Batteries are not included, we recommend "ready to use" NiMh batteries.
-WORKS WITH LINNDRUMM ONLY, NOT FOR LM-1.
-7pin power plug, please check if your linndrum has the 7pin (and NOT the 10pin) molex connector before you order!
-To avoid damage to your Linndrum, we recommend to have this unit installed by a qualified electronics engineer.
-Installing this powersupply is at your own risk.
works like a charm. Had the Moog/Soma tech in So Cal pop it in as the OG board had been repaired a few times and new old stock batteries would last just a few weeks before failing
Big ups Synth City ! My LM2 is back on it's feet.
The easiest update I've ever done. It seriously takes longer to update the firmware on some synths than it did to replace this board. No more battery leak worries, and problems I had with the tempo varying wildly when I used the tempo pot disappeared. I highly recommend this upgrade - it was easy to install and should give me many years free from worry.
Also, ordering from SynthCity was easy, inexpensive, and fast - from Netherlands to Brooklyn, New York in about 10 days.